Specifying Whether To Enable Or Disable The System Retry Function When A Transmission Error Occurs - Master And Satellite - Sharp ER-A770 Instruction Manual

4. Specifying whether to enable or disable the system retry
function when a transmission error occurs — master and satellite
You can specify whether the system retry function is disabled or enabled if the communication
between machines does not end successfully.
NOTE
• If the system retry function is enabled, a transmission job with which an error has occurred is
not finalized immediately, but the master waits for selection of one of the three commands
(RETRY, ABORT and IGNORE) through the keyboard. Then the master retries access to the
satellite that has caused the transmission error or terminates the access as a successful or
unsuccessful transmission depending on the selection made.
• If the function is disabled, the job is terminated immediately.
• The default setting is "ENABLE."
1.
Enter the PGM2 mode.
2.
Select "INLINE SETTING" and press the [ENTER]
key.
The INLINE SETTING menu will open.
3.
Move the cursor to the "SYSTEM ENTRY" line.
Select "DISABLE" or "ENABLE" with the [ • ] key
(toggle key) and press the [ENTER] key.
31