Setting The Parking Brake - Craftsman 108.27807 Operator's Manual

Front and Rear Brake Control
WARNING
Never operate the ATV with a spongy feeling brake lever. Operating the ATV with a
spongy brake lever can result in loss of braking. Loss of braking could cause an
accident.
The front and rear brake
control is located on the
left handlebar and
operated by the left hand.
The front and rear brakes
are hydraulically activated
disc type brakes, which
are activated by one
control only. Always test
brake lever travel and
reservoir fluid level before
riding. When squeezed,
the lever should feel firm.
Any sponginess would indicate a possible fluid leak or low master cylinder fluid
level which must be corrected before riding. Contact 1-800-643-7332 for proper
diagnosis and repairs.

Setting the Parking Brake

WARNING
Always check to be sure that the parking brake has been disengaged before
operating the ATV. An accident could result causing severe injury if the parking
brake is left on while the ATV is operated.
1. Squeeze the left hand
brake lever two or
three times and hold it.
2. Push the park brake
lock (1) into the
notches (2) on the
master cylinder body.
Release the brake
lever.
3. To release the parking
brake lock, squeeze
the brake lever. It will
Front and Rear Brake Control Lever
1
32
2