Steering Inspection; Camber And Caster - Craftsman 108.27807 Operator's Manual

Steering Inspection

The steering assembly of the ATV should be checked periodically for loose nuts
and bolts. If loose nuts and bolts are found, have your dealer tighten them before
riding your vehicle.

Camber and Caster

The camber and caster are non-adjustable.
Toe Alignment Check
WARNING
Do not attempt to adjust the tie rod for toe alignment. Severe injury or death can
result from improper adjustment. Contact 1-800-643-7332 to arrange for proper
adjustment.
The recommended toe alignment is 1/8˝ to 1/4˝ (3 to 6mm) toe out.
1. Set the handlebars in a
straight -ahead position and hold
them in this position.
2. Measure A and B. A minus
3. B should be 1/16˝ to 1/8˝(1.5 to
3mm).
4. If this measurement needs to be
adjusted, contact your dealer for
service.
63