Checking The Group Settings - Sanyo VSP-8000 Instruction Manual

CHECKING THE GROUP SETTINGS

When you set the groups, each device stores the information regarding which group it belongs to in their memory. When you perform
a group check, the group information is read from each device connected via the RS-485 interface and the group settings are
renewed. For more information regarding the group settings, refer to GROUP SETTING on page 38.
1
Press the MENU button.
Then press the + (or – ) button until " GROUP CHECK" is displayed
and press the ENTER button.
•
The group check screen appears.
Note: Press the CLEAR button to return to the "GROUP CHECK" screen.
2
Press the ENTER button.
•
Performs the group check. During the check, the cursor will move to the right.
•
When the group check is completed, the data gathered is stored in memory
and the "GROUP CHECK" screen reappears.
Press the MENU button to return to the initial screen.
Note:
•
If group settings were changed at another controller, always perform the group check and save the group settings.
•
If a device belonging to group has its address changed, is removed from the system, or is changed to another group, then be
sure to perform the group check and save the changed group settings.
•
Do not operate a controller while one controller is performing a group check.
MENU
14
- +
G R O U P C H E C K ?
O K : E N T E R N O : C L R
ENTER
ENTER
G R O U P C H E C K