Built-in 10/100/1000BASE-T ports cannot be trunked with GBIC ports.
To add a port to a trunk, click the toggle button below the port number until the correct trunk number appears.
NOTICE:
All ports participating in a trunk must be operating in Full Duplex mode.
NOTICE:
All ports participating in a trunk should have the same VLAN and CoS settings.
To save any changes you make in this page, click Apply. To reset these fields to their current value, click Reload.
Port Mirroring
From the Port Mirroring page, you can enable or disable port mirroring. You can also set the source port and monitor ports. Port mirroring helps you debug a
network.
The following options are available:
Port Mirroring is — Enable or disable port mirroring.
l
Source Port — Port from which all traffic will be mirrored to the monitor port.
l
Monitor Port — Port that receives a copy of all traffic that the source port receives.
l
To save any changes you make in this page for the current session, click Apply. To reset these fields to their current value, click Reload.
SNMP
The SNMP menu contains links to the following pages: