Toshiba e-STUDIO165 Service Manual page 280

[A] Precaution when writing the data
• Set the writing voltage (VID) to 3.3V.
• When writing the data, set the address from 0 to 3FFFFF. The data may not be written correctly if it
is not set.
• The Flash ROM in which the data will be written, on the download jig is selected by switching the
rotary switch on the adapter. Be sure to switch the rotary switch on the adapter depending on the
data (file) to be written.
Important:
When an error such as "Over current detects" appears while the data are being written to the
download jig and the writing cannot be finished, set the writing voltage (VID) to 12 V and then
write them.
Rotary Switch
1
2
3
4
5
6
Rotary Switch
1
2
3
4
5
6
Note: Note:
Be sure not to confuse different ROM Versions since the file name is identical although the ROM
version is different.
e-STUDIO165/167/205/207/237
FIRMWARE UPDATING
System ROM
File Name
rom_H. bin
N/A
N/A
N/A
N/A
N/A
Controller ROM
File Name
firmImage0.bin
firmImage1.bin
firmImage2.bin
firmImage3.bin
N/A
N/A
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 8
08/04
Flash ROM
ROM1
ROM2
ROM3
ROM4
ROM5
ROM6
Flash ROM
ROM1
ROM2
ROM3
ROM4
ROM5
ROM6