Configuring For Bridge Mode - Motorola 2200 Administrator's Handbook

Configuring for Bridge Mode
Browse into the Motorola Netopia® Gateway's web interface.
1.
Click on the Configure
2.
Click on the LAN
3.
The LAN page appears.
In the box titled LAN IP Interface (Ethernet
4.
100BT):
Make note of the Ethernet IP Address and subnet mask.
You can use this address to access the router in the future.
Click on the Advanced
5.
toolbar.
Under the heading of Services, click on the
6.
net Bridge link.
The Ethernet Bridge page appears.
The appearance of this page varies, depending on your
Gateway's interfaces.
If available:
7.
a. Check the Enable Bridging on Port selection. (This
may be Always On.)
Submit
b. Click .
If you want the Gateway to do both bridging
8.
and routing, check the
Bridging/Routing
When this mode is enabled, the Gateway will appear to
be a router, but also bridge traffic from the LAN if it has
a valid LAN-side address.
Check the Enable System Bridge
9.
The window shrinks.
button in the upper Menu bar.
link.
link in the left-hand links
Enable Concurrent
checkbox.
checkbox.
Ether-
105