System Log: Entire - Motorola 2200 Administrator's Handbook

Administrator's Handbook
Link:

System Log: Entire

The system log shows the state of the WAN connection as well as the PPPoE session. Verify that the
PPPoE session has been correctly established and there are no failures. If there are error messages, go
to the WAN configuration and verify the settings. The following is an example of a successful connection:
Message Log:
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
.
.
Mon Apr 16 10:48:22 2007 L4
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:48:22 2007 L3
Mon Apr 16 10:50:02 L4
Mon Apr 16 10:50:02 L4
Mon Apr 16 10:50:02 L4
216
KS: Using configured options found in flash
BOOT: Warm start v7.3r0 ----------------------------------
IP address server initialization complete
BR: Using saved configuration options
BR: Netopia SOC OS version 7.3.0 (build r0)
BR: Netopia-3000/9495032 (Netopia-3000, rev 1), PID 1205
BR: last install status: Firmware installed successfully
BR: memory sizes - 2048K Flash, 8192K RAM
BR: Starting kernel
AAL5: initializing service
ATM: Waiting for PHY layer to come up
POE: Initializing PPP over Ethernet service
POE: Binding to Ethernet (ether/vcc1)
BRDG: Configuring port (10/100BT-LAN)
BRDG: Bridge not enabled for WAN.
BRDG: Bridging from one WAN port to another is disabled
BRDG: Initialization complete
IP: Routing between WAN ports is disabled
IP: IPSec client pass through is enabled
IP: Address mapping enabled on interface PPP over Ethernet vcc1
IP: Adding default gateway over PPP over Ethernet vcc1
IP: Initialization complete
IPSec: initializing service
IPSec: No feature key available - service disabled
PPP: PPP over Ethernet vcc1 binding to PPPoE
PPP: PPP over Ethernet vcc1 Port listening for incoming PPP connection requests
RFC1483-1 up
Service-Name=ANY
Host-Uniq 00000001
AC-Name=62011050058192-SMS1800
Service-Name=ANY
lcp: LCP Send Config-Request+
MAGIC 0x2dee0000+
lcp: LCP Recv Config-Req:+
MRU(1492) (ACK) AUTHTYPE(c223) (CHAP) (ACK) MAGICNUMBER
(4403604) (ACK)
lcp: returning Configure-Ack
chap: received challenge, id 1
chap: received success, id 1
ipcp: IPCP Config-Request+
ADDR(0x0) DNS(0x0) DNS2(0x0) WINS(0x0) WINS2(0x0)
ipcp: IPCP Recv Config-Req:+
ADDR(143.137.199.254) (ACK)
ipcp: returning Configure-ACK
ipcp: IPCP Config-Request+
ADDR(0x0) DNS(0x0) DNS2(0x0)
ipcp: IPCP Config-Request+
ADDR(0x8f89c702) DNS(0x8f89320a) DNS2(0x8f898909)
ipcp: negotiated remote IP address 143.137.199.254
ipcp: negotiated IP address 143.137.199.2
ipcp: negotiated TCP hdr compression off
NTP: Update system date & time
TS: "admin" logging in on serial port 0
TS: "Admin" completed login: Full Read/Write access
TS: "Admin" completed login: Full Read/Write access