Bridging Settings - Motorola 2200 Administrator's Handbook

Administrator's Handbook
set atm [vcc n ] vpi { 0 ... 255 }
Select the virtual path identifier (vpi) for VCC n.
Your Service Provider will indicate the required vpi number.
set atm [vcc n ] vci { 0 ... 65535 }
Select the virtual channel identifier (vci) for VCC n. Your Service Provider will indicate the required vci num-
ber.
set atm [vccn] encap { ppp-vcmux | ppp-llc | ether-llc |
Select the encapsulation mode for VCC n. The options are:
ppp-vcmux
ppp-llc
ether-llc
ip-llc
pppoe-vcmux
pppoe-llc
Your Service Provider will indicate the required encapsulation mode.
set atm [vccn] pppoe-sessions { 1 ... 8 }
Select the number of PPPoE sessions to be configured for VCC 1, up to a total of eight. The total number of
pppoe-sessions and PPPoE VCCs configured must be less than or equal to eight.

Bridging Settings

Bridging lets the Motorola Netopia® Gateway use MAC (Ethernet hardware) addresses to forward non-TCP/
IP traffic from one network to another. When bridging is enabled, the Motorola Netopia® Gateway maintains
a table of up to 512 MAC addresses. Entries that are not used within 30 seconds are dropped. If the bridg-
ing table fills up, the oldest table entries are dropped to make room for new entries.
Virtual circuits that use IP framing cannot be bridged.
☛
NOTE:
For bridging in the 3341 (or any model with a USB port), you cannot set the bridge option off,
or bridge ethernet option off; these are on by default because of the USB port.
246
ip-llc | ppoe-vcmux | pppoe-llc }
PPP over ATM, VC-muxed
PPP over ATM, LLC-SNAP
RFC-1483, bridged Ethernet, LLC-SNAP
RFC-1483, routed IP, LLC-SNAP
PPP over Ethernet, VC-muxed
PPP over Ethernet, LLC-SNAP