Wan Commands - Motorola 2200 Administrator's Handbook

who
Displays the names of the current shell and PPP users.

WAN Commands

atmping vccn [ segment | end-to-end ]
Lets you check the ATM connection reachability and network connectivity. This command sends five Opera-
tions, Administration, and Maintenance (OAM) loopback calls to the specified vpi/vci destination. There is a
five second total timeout interval.
Use the segment argument to ping a neighbor switch.
Use the end-to-end argument to ping a remote end node.
reset dhcp client release [ vcc-id ]
Releases the DHCP lease the Motorola Netopia® Gateway is currently using to acquire the IP settings for
the specified DSL port. The
map to the VCC in use. Enter the
see the letter assigned to each virtual circuit.
reset dhcp client renew [ vcc-id ]
Releases the DHCP lease the Motorola Netopia® Gateway is currently using to acquire the IP settings for
the specified DSL port. The
map to the VCC in use. Enter the
assigned to each virtual circuit.
reset dsl
Resets any open DSL connection.
reset ppp vccn
Resets the point-to-point connection over the specified virtual circuit. This command only applies to virtual
circuits that use PPP framing.
show atm [all]
Displays ATM statistics for the Motorola Netopia® Gateway. The optional all argument displays a more
detailed set of ATM statistics.
show dsl [ all ]
Displays DSL port statistics, such as upstream and downstream connection rates and noise levels.
vcc-id
identifier is an "index" letter in the range B-I, and does not directly
reset dhcp client release
vcc-id
identifier is an "index" letter in the range B-I, and does not directly
reset dhcp client release
command without the variable to
without the variable to see the letter
239