Adjustment Of The Radf (Mr-3020) - Toshiba e-STUDIO230L Service Handbook

3.11 Adjustment of the RADF (MR-3020)

3.11.1 Adjustment of RADF Position
Perform this adjustment when the RADF is not installed in the correct position.
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF.
[A] Checking
(1) Open the RADF and install 2 positioning pins
(the positioning pins are installed to the back
side of the hinge which is on the left side of
the RADF).
(2) Remove the platen sheet.
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved
Fig. 3-79
Fig. 3-80
e-STUDIO200L/202L/203L/230/232/233/280/282/283
3 - 69
05/11
3
ADJUSTMENT