[EAF0] Stack return jam
MJ-1022
Is there any paper remaining on the transport path in the finisher or equipment?
YES
NO
Is the connector J10 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and returning roller home position
sensor (S3) open circuited?
YES
NO
Is the returning roller home position sensor working properly?
l
NO
l
YES
Replace the finisher controller PC board.
e-STUDIO200L/202L/203L/230/232/233/280/282/283
TROUBLESHOOTING
Remove the paper.
Connect the connector securely. Replace the harness.
1) Connect the connector of the returning roller home position sensor
securely.
2) Replace the returning roller home position sensor.
5 - 44
© 2004 - 2007 TOSHIBA TEC CORPORATION All rights reserved