Hitachi Compute Blade 500 Series System Overview Manual page 22

Location
2
3
4
5
6
7
8
1-14
Name
NMI reset switch
KVM port
Power switch with Power LED
Location Identify LED (LID)
Attention LED (ATN)
Alarm LED (ALM)
Diagnostic Panel LP
System Overview
Hitachi Compute Blade 500 Series System Overview Guide
State
-
-
-
Green-On
Green-Blink
Blue-On
Amber-On
Amber-On
Green-On
S BRD Amber-On
MIS Amber-On
Description
Press this switch to issue a
Non-Maskable Interrupt
(NMI) of the server blade.
Provides VGA, serial port
and 2 USB port outputs.
Connect a KVM cable to
1
this port.
Press this switch to power-
on.
Press and hold this switch
for four seconds or more
to force the main power-
2
off.
Main power of the server
blade is turned on.
Main power of the server
blade is turned off.
Slow blink: The server
blade is ready to be turned
on.
Rapid blink: The server
blade is initializing.
Identifies the server blade.
Configuration mismatch
errors other than failures
are detected in the server
blade, such as the installed
Mezzanine card does not
correspond to or does not
support the switch module.
Indicates explicitly that the
power button with LED was
pressed. The LED is turned
on when you press the
power button, and then
turned off when the main
3
power is turned on.
Indicates a fault that
requires an HDD to be
exchanged was detected in
the server blade.
The LED panel on the
diagnostic panel is active.
The motherboard needs to
be replaced.
Unsupported combination
of the DIMM, CPU, and
HDD.