Switches, Indicators And Connectors (Half-Wide Blade Cb 520H B3) - Hitachi Compute Blade 500 Series System Overview Manual

Location
Notes:
1 When using the USB port of KVM cable except keyboard and mouse, you should use
.
the device with a rated maximum current limit 500 mA per two ports, or the USB
device that can be external powered.
2 When POWER LED starts blinking from lighting solid, release the button. If you press
.
the power switch for six seconds or more, the power may turn on after forced turn-
off. If so, check that HDD access LED is not illuminated, and then press and hold the
power button for four seconds or more.
3 Error cannot be displayed while from pressing the power button until turning on the
.
main power.

Switches, Indicators and Connectors (Half-wide blade CB 520H B3)

Table 1-8 Server Blade Switches, Indicators and Connectors (Half-wide
Location
1
2
3
Name
Figure 1-19 Server Blade (Half-wide blade CB 520H B3)
Name
USB port
NMI reset switch
KVM port
System Overview
Hitachi Compute Blade 500 Series System Overview Guide
State
NMI Amber-On
TEMP Amber-On
MEM Amber-On
ADJ -
blade CB 520H B3)
State
-
-
-
Description
A Non-Maskable Interrupt
(NMI) was generated.
The maximum
temperature limit was
exceeded.
A memory failure was
detected.
Not supported.
Description
USB port in the server
blade.
Press this switch to issue a
Non-Maskable Interrupt
(NMI) of the server blade.
Provides VGA, serial port
and 2 USB port outputs.
1-15