Hitachi Compute Blade 500 Series System Overview Manual page 26

Location
1
2
3
4
5
6
7
8
1-18
Table 1-9 Server Blade Switches, Indicators and Connectors
Name
USB port
NMI reset switch
KVM port
Power switch with Power LED
Location Identify LED (LID)
Attention LED (ATN)
Alarm LED (ALM)
Diagnostic Panel LP
System Overview
Hitachi Compute Blade 500 Series System Overview Guide
State
-
-
-
-
Green-On
Green-Blink
Blue-On
Amber-On
Amber-On
Green-On
S BRD Amber-On
Description
USB port in the server
blade.
Press this switch to issue a
Non-Maskable Interrupt
(NMI) of the server blade.
Provides VGA, serial port
and 2 USB port outputs.
Connect a KVM cable to
1
this port.
Press this switch to power-
on.
Press and hold this switch
for four seconds or more
to force the main power-
2
off.
Main power of the server
blade is turned on.
Main power of the server
blade is turned off.
Slow blink: The server
blade is ready to be turned
on.
Rapid blink: The server
blade is initializing.
Identifies the server blade.
Configuration mismatch
errors other than failures
are detected in the server
blade, such as the installed
Mezzanine card does not
correspond to or does not
support the switch module.
Indicates explicitly that the
power button with LED
was pressed. The LED is
turned on when you press
the power button, and
then turned off when the
main power is turned on.
Indicates a fault that
requires an HDD to be
exchanged was detected in
the server blade.
The LED panel is active.
The motherboard needs to
be replaced.
3