Cutting Hair - Silvercrest SHBS 1000 A1 Operation And Safety Notes

Use

Cutting hair

Q
Tip: Start with a cutting length comb attachment with a longer cutting
length than is finally required, then proceed in stages until you achieve
the desired length.
Cutting length comb attachments
j
S elect the cutting length comb attachment
10 - 12 mm / 16 - 18 mm / 22 - 24 mm / 28 - 30 mm) to suit the desired
cutting length.
j
P ush the selected cutting length comb attachment
on to the blade set
engage properly into the recesses in the sides of cutter head mount.
Note: By adjusting the setting of the sliding switch
finely graduate the desired cutting length of the cutting length comb
attachments
for a hair length of 22 - 24 mm and would like to cut your hair to
22 mm, then slide the sliding switch
the cutting length as far as it will go upwards (0.5 mm). Stepping
the fine adjustment setting switch downwards increases the cutting
length to 22.7 mm (with a fine adjustment of 1.2 mm); to 23.4 mm
(with a fine adjustment of 1.9 mm) or to 24 mm (with a fine adjust-
ment of 2.5 mm).
Cutting length comb
attachment 6 (mm)
4 - 6
7 - 9
10 - 12
16 - 18
16 GB
. Ensure that the two pins on the attachment
1
. If you select the cutting length comb attachment
6
with cutting length fine adjustment (mm)
0.5
4.0
7.0
10.0
16.0
:
6
(4 - 6 mm / 7 - 9 mm /
6
for the fine adjustment of
2
Cutting lengths*
1.2 1.9
4.7 5.4
7.7 8.4
10.7 11.4
16.7 17.4
from the rear
6
you can
2
6
2.5
6.0
9.0
12.0
18.0