NEC EXPRESS5800 User Manual page 47

Apply to Redundant
Logical Drives
Do not use the options with "*unavavailable" suffixed in the above list.
5. After the settings are completed, click [Submit].
Click [Back] to return to the previous screen. Click [Cancel] to cancel the settings.
If redundancy check is scheduled, the screen display changes to the schedule list screen. The
scheduling just set is added to the list. Message "schedule was created successfully." appears at
the top of the tab.
The above procedure can make scheduling.
If the time reaches to the start time having been set, the redundancy check is started. The
redundancy check is repeated at the intervals entered in step 3.
IMPORTANT: Redundancy check without Auto Fix of a
logical drive not full-initialized or not subject to
redundancy check in the Auto Fix mode at all cannot be
scheduled.
If you try, the following message is registered and
redundancy check is not done.
Failed to create the scheduler: Redundancy
Check can not be scheduled for logical drive
x as it is not fully initialized or AutoFix
is not enabled.
In this case, run redundancy check in Auto Fix once.
Changing schedule setting
1. Click the subsystem (ST EX4650EL) icon in the Tree View.
2. Click the Scheduler tab in the Management Window and then click the link of the redundancy
check for which you want to change the schedule setting.
The following procedure is the same as that for creating a schedule.
Suspending (deleting) schedule setting
1. Click the subsystem (ST EX4650EL) icon in the Tree View.
2. Click the arrow at the right end of the Scheduler tab in the Management Window and then
Check the checkboxes of logical drives for which you want to
schedule redundancy check.
- -
42