Enabled
Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled.
Scanner Selection
Configures which scanning device to use for bar code data capture when the profile is active.
•
Auto - The software automatically determines the best scanning device. If a Scan Module or Scan/MSR
Module is installed on the ET1, then the 2D imager is selected. Otherwise the camera is selected.
•
Camera scanner - Scanning is performed with the rear-facing camera.
•
2D Imager - Scanning is performed using the installed Scan or Scan/MSR module.
Decoders
Configures which bar code decoders are enabled or disabled. For best performance disable all unnecessary
decoders.
Touch Decoders. The Barcode input screen appears. A check in the checkbox indicates that the decoder is
enabled. By default the most commonly used decoders are enabled (shown below with an asterisk). The
supported decoders are:
•
UPC-A*
•
EAN-8*
•
Interleaved 2 of 5
•
GS1 DataBar Expanded*
•
PDF417*
•
MicroQR
•
MicroPDF
•
UK Postal
•
Canadian Postal
•
Codabar*
•
Trioptic 39
•
Korean 3 of 5
•
Webcode
Touch
to return to the previous screen.
Decoder Params
Use Decode Params to configure individual decoder parameters. Touch Decode Params. The Decode
params screen appears.
Touch the decoder parameter to modify.
UPC-E0*
Code 128*
GS1 DataBar*
Datamatrix*
Composite AB
Aztec*
USPostnet
Japanese Postal
Dutch Postal
MSI
Discrete 2 of 5
Code 11
Matrix 2 of 5
DataWedge Configuration
EAN-13*
Code 39*
GS1 DataBar Limited
QR Code*
Composite C
Maxicode*
USPlanet
Australian Postal
US4state FICS
Code 93
Chinese 2 of 5
TLC 39
UPC-E1
4 - 9