Motorola ET1 Integrator Manual page 69

•
MSI
•
Length 1 - Use to set decode lengths (default - 4). See
information.
•
Length 2 - Use to set decode lengths (default - 55). See
information.
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - enabled).
•
Check Digit - With MSI symbols, one check digit is mandatory and always verified by the reader. The
second check digit is optional.
• One Check Digit - Verify one check digit (default).
• Two Check Digits - Verify two check digits.
•
Check Digit Scheme - Two algorithms are possible for the verification of the second MSI check digit.
Select the algorithm used to encode the check digit.
• Mod-11-10 - First check digit is MOD 11 and second check digit is MOD 10 (default).
• Mod-10-10 - Both check digits are MOD 10.
•
Report Check Digit - Transmit MSI data with or without the check digit. A check in the checkbox
indicates to send MSI data with check digit (default - disabled).
•
Code93
•
Length1 - Use to set decode lengths (default - 0). See
information.
•
Length2 - Use to set decode lengths (default - 55). See
information.
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - disabled).
•
Discrete 2 of 5
•
Length1 - Use to set decode lengths (default - 0). See
information.
•
Length2 - Use to set decode lengths (default - 14). See
information.
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - enabled).
•
Code11
•
Length1 - Use to set decode lengths (default - 4). See
information.
•
Length2 - Use to set decode lengths (default - 55). See
information.
•
Redundancy - Sets the reader to read the bar code twice before accepting data. A check in the
checkbox indicates that redundancy is enabled (default - enabled).
•
Verify Check Digit - Check the integrity of all Code 11 symbols to verify that the data complies with
the specified check digit algorithm. This selects the check digit mechanism for the decoded Code 11
bar code.
• No Check Digit - Do not verify check digit.
• 1 Check Digit - Bar code contains one check digit (default).
DataWedge Configuration 4 - 13
Decode Lengths on page 4-14
Decode Lengths on page 4-14
Decode Lengths on page 4-14
Decode Lengths on page 4-14
Decode Lengths on page 4-14
Decode Lengths on page 4-14
Decode Lengths on page 4-14
Decode Lengths on page 4-14
for more
for more
for more
for more
for more
for more
for more
for more