Removing A Blade; Assigning Ip Phones To Etia Blades; Chapter 4 Standard View - NEC UNIVERGE SV9100 Programming Manual

3.3
3.4
4-6
3. Select a blade type relevant to the blade to install.
4. Another popup menu appears listing blades associated with the
selected blade type.
5. Select the desired blade package you want to add.
The slot changes appearances to indicate the blade that is installed, the firmware
version, the port type and the port range that is used.

Removing a Blade

To remove a blade, complete the following steps:
1. With the mouse, right click on the blade you want to remove.
2. When the popup menu is displayed, select Delete Card.
The blade is removed and the slot and port type range it was utilizing is now
available for use by another blade.

Assigning IP Phones to ETIA Blades

To assign an IP to an ETIA blade, complete the following steps:
1. Click on the IP to ETIA button.
2. Right click on the IP phone to assign it to the ETIA blade.
3. Select the ETIA blade to which the IP phone is connected.
❍
IMPORTANT
❍
Selecting External Hub means the phone is not connected to
an ETIA blade.
Set the phone type using PRG 15-05-26 to ensure the correct
power factor is assigned by the system.
ISSUE 2.0
Standard View