Department Groups - NEC UNIVERGE SV9100 Programming Manual

To setup up a Department Group:
1.
2.
3.
4.
5.
6.
7.
4-18
Specify a Department Group to modify.
Specify basic characteristics (Basic Settings) of the Department Group.
The Basic Settings section basic characteristics of the selected Department
Group. These settings are linked with 16-01.
Select the extensions that are Primary Members of the Department Group.
All extensions that are Primary Members of the selected Department Group are
listed. Every extension must belong to one of the 64 available Department
Groups. By default, all extensions are Primary Members of Department Group
1. By removing an extension from Department Group 1 it is automatically
assigned to Department Group 64. These settings are linked with 16-02.
Specify the priority for the selected Primary Members.
When an extension is selected as a Primary Member it automatically appears
in the priority list (the list to the bottom of the Primary Member list). The priority
of the selected extension can be modified by the following key combinations:
Shift + Up Arrow

Shift + Down Arrow

Shift + Page Up

Shift + Page Down

Shift + Home

Shift + End

Select the extensions (maximum of 16) that are Secondary Members of the
Department Group.
All extensions that are Secondary Members of the selected Department Group
are listed. A maximum of 16 extensions can be assigned as Secondary
Members. These settings are linked with 16-03.
Specify the priority for the selected Secondary Members.
When an extension is selected as a Secondary Member it automatically
appears in the priority list (the list to the bottom of the Secondary Member list).
The priority of the selected extension can be modified by using the same key
combinations as in the case of setting the priority for Primary Members.
Increase priority by 1
Decrease priority by 1
Increase priority by one page
Decrease priority by one page
Make highest priority
Make lowest priority
ISSUE 2.0
Standard View