Figure 4-7 Standard View Telephone Setup Multiassign Dialog - NEC UNIVERGE SV9100 Programming Manual

To assign properties to a block of telephones:
1.
2.
3.
4-12
Select the area of cells to be assigned in a block.
Right click the mouse within the selected area. The MultiAssign dialog box is
displayed. (Refer to Figure 4-6 Standard View Telephone Setup on page
The MultiAssign dialog is filled with the values from the top most selected lines.
If any cells on that line are disabled, the default value for that item is used.
Columns that are not selected are disabled.

Figure 4-7 Standard View Telephone Setup MultiAssign Dialog

Make your selections and click OK. All selected telephones are assigned the
values in the MultiAssign dialog box.
ISSUE 2.0
4-10.)
Standard View