GE AIR F24 Service Manual page 26

Operating Procedures / Photos
Disassemble Front Panel Assy
Use screwdriver to screw off the six screws
shown in the figure (two screws at the left,
right and rear sides respectively), remove
the front panel assy toward the direction
shown in the figure to remove it (refer to
figures 8-6, 8-7).
Disassemble Guide Louver Sub-assy
First remove the guide louver from the fitting
position of the guide louver support, then
remove the two ends of the guide louver
from the fitting position of the swing motor.
(Fig 8-8)
Disassemble Water Tray Sub-assy
Use screwdriver to screw off the three
screws shown in the figure so as to remove
the water tray sub-assy (refer to Figure 8-9).
Screw
(Fig 8-6)
Motor fitting position
－26－
Screw
(Fig 8-7)
Support
(Fig 8-8)
Screw
(Fig 8-9)