GE AIR F24 Service Manual page 27

Operating Procedures / Photos
Disassemble Mounting Plate Sub-assy of Swing Louver
Use screwdriver to screw off the screws at
both ends of the mounting plate sub-assy of
swing louver. Take the mounting plate
sub-assy of swing louver apart from the guide
louver support. (Fig 8-10)
Disassemble Evaporator Assy
Use screwdriver to screw off the screw shown
in the figure. Remove the tube-exit clamp
sub-assy of evaporator. (Fig 8-11)
Use screwdriver to screw off the screw shown
in the figure and remove the evaporator assy.
Handle with care. (Fig 8-12、Fig 8-13)
Disassemble Air Outlet Rear Side Plate Sub-assy
First remove the velvet sheet and the left and
right side plate cushions at the air outlet; then
use screwdriver to screw off the screw shown
in the figure. (Fig 8-14)
Screw
(Fig 8-11) Screw
－27－
Support
(Fig 8-10)
Screw (Fig 8-12)
Screw
(Fig 8-13)
Screw
(Fig 8-14)