Advertisement
Operating Procedures / Photos
Disassemble Capillary
Unsold the soldering points at the capillary,
the valve and the condenser to remove the
capillary. Pay attention not to allow the
soldering slag to block the capillary.
(Fig 8-59)
Disassemble Valve
Unscrew the two screws fixing the gas valve,
unsolder the soldering point between the gas
valve and the return-air duct and remove the
gas
valve
(note:
soldering point, use wet cloth to completely
wrap the gas valve to prevent valve body from
being harmed by high temperature).
Unscrew the two screws fixing the liquid valve,
unsolder the soldering point connecting the
liquid valve and the fork type pipe, and remove
the liquid valve.
(Fig 8-60)
Disassemble Compressor
Firstly unsolder the pipes connecting the
compressor, and then unscrew the three foot
nuts at the compressor to remove the
compressor. (Fig 8-61)
when
unsoldering
Capillary
the
Liquid Valve
Foot Nut
－39－
Screw
Gas Valve
Advertisement
