2.7 Help
A
•
In addition, the following data cannot be restored:
Setting Features
Q
How do I change the dialling mode of an analogue trunk?
A
•
Q
How do I set disconnect detection (CPC Detection) for an analogue trunk?
A
•
102
PC Programming Manual
The following setting data is not saved to the SD memory card, so will be deleted when
the PBX is initialised. This data is stored in the PBX's battery backup memory.
•
Incoming Call Log
•
Outgoing Call Log (including Last Number Redial)
•
Message Waiting
•
SMDR
•
Advice of Charge (AOC)/Pay Tone
•
Hospitality guest billing data
•
ICD Group monitor log for supervisor
•
PBX date and time
•
Timed Reminder
•
LPR Timed Update time
•
PT handset/headset volume
•
PT SP-PHONE volume
•
PT ring volume
•
PT display contrast
•
ICD Group login status
(All extensions are set to Login by default.)
•
ICD Group Ready/Not Ready status
(All extensions are set to Ready by default.)
•
Live Call Screening (LCS) On/Off
•
Hands-free Answerback status
•
Absent Message status of extensions
(Absent Message data itself is not cleared.)
•
FWD/DND status
(FWD destinations are not cleared.)
•
Extension Dial Lock/Remote Extension Dial Lock
•
Extension PIN Lock/Extension PIN Lock counter
•
Verification Code PIN Lock/Verification Code PIN Lock counter
•
Password Lock counter for Remote System Programming
•
PBX Error Log
•
Digital Trunk Error Report data
•
SVM Log and messages (both greeting messages and voice messages left by
callers) recorded in an SVM/ESVM card
From the 2.8.11 [1-1] Slot—Port Property - LCO Port screen, change the Dialling
Mode setting of the target port to "DTMF" or "Pulse", as required.
From the 2.8.11 [1-1] Slot—Port Property - LCO Port screen, modify the CPC Signal
Detection Time—Outgoing, Incoming setting of the target port.
The required value varies by carrier. Transmission and reception can be set separately.