Panasonic KX-NCP0158 Quick Installation Manual page 46

8 Registering IP Cell Stations
6. a.
Highlight IP-CSs and click the right arrow to select
them for registration.
b.
Click Next. A screen will appear with information
on the selected IP-CS for programming.
Note
•
•
c.
If the registration is still in progress, the dialogue
box will show "Registration Executing".
If the registration is successful, the dialogue box
will show "Registration Completed". Click Close.
Once the IP-CS is successfully registered, the status of the IP-CS will update to show "Registered".
Note
When you need to change the Master CSs (Master CS1 and Master CS2) to different CSs, refer
to "Assigning the Synchronising CSs".
Assigning the Synchronising CSs
Assigning the Master CSs
Note
•
When using IP-CSs and traditional CSs in the same area, the traditional CSs must be classified as
Master CS1.
•
When using IP-CSs and traditional CSs in the same area, make sure that you do not create a Master
CS2.
•
When using only one IP-CS at an installation site, assign it as Master CS1 so that it can generate the
clock signal.
1.
Under Maintenance, click Air Synchronisation.
2.
Select the desired cell in the Connection column, and then click Command to change the status of the
port to "OUS".
46 Quick Installation Guide
If the IP-CS has been connected to the LAN
and power has been turned on, the IP
address of the PBX will be assigned
automatically.
If not, connect the IP-CS to the LAN and
turn the power on within 15 minutes after
this operation is done. For details, refer to
"Connecting an IP-CS to a LAN". The IP
address of the PBX will then be assigned
automatically.