Powering On Or Off The Endpoint - Huawei TE40 User Manual

HUAWEI TE40&TE50&TE60 Videoconferencing Endpoint
User Guide
After connecting all the required devices, connect the power supply and then power on the
endpoint.
l When the endpoint is powered on, ensure that the power cable is connected to the endpoint
l Before disconnecting the external power supply (for example, the power supply from a power
Check whether the power cable and the power adapter are connected to the relevant devices
properly. Ensure that:
l
l
To power on the endpoint, slide the power switch on the rear panel to the ON position.
To power off the endpoint, perform either of the following operations:
l
l
Depending on the endpoint's status, the indicators on the front panel may blink in different colors
and at different rates, as listed in
Issue 02 (2014-01-15)
4

Powering On or Off the Endpoint

NOTICE
securely to prevent power disconnection.
socket), power off the endpoint properly.
The voltage of the alternating current ranges from 100 V to 240 V and the frequency of the
alternating current ranges from 50 Hz to 60 Hz.
The sequence of and voltage difference between the live wire, neutral wire, and ground
cable comply with the relevant international standards. In addition, ensure that the ground
cable is properly grounded.
Press on the remote control. Confirm the power-off action in the displayed dialog box.
Slide the power switch on the rear panel to the OFF position.
NOTE
When the endpoint is powered off using the remote control, the indicator on the front panel turns orange,
but the power switch on the rear panel is still in the ON position. To power on the endpoint again, press
on the remote control.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Table 4-1 and Table 4-2.
4 Powering On or Off the Endpoint
10