Checking Cooling System; Installing Steering Wheel - Toro UTV500AAC00000 Setup Instructions

7. Install the seat belts (cap screws installed from the
front) into the appropriate mounting tabs along the
headrest support tube on the rear ROPS. Tighten to
47 N-m (35 ft-lb).
8. Place Right-Side Occupant Side Restraint onto the
passenger-side tube and secure using four Cap
Screws. Tighten to 13.5 N-m (10 ft-lb).
9. Secure the outer side restraint using two Cap
Screws making sure to keep the straps properly
positioned.
10. Route the lower side restraint straps inside the side
tube; then secure to the frame using two Shoulder
Screws and Flange Nuts. Tighten to 13.5 N-m (10
ft-lb).
11. Loop the rear anchor strap around the ROPS mount-
ing tube and secure with the buckle. Tighten so
strap rests as shown.
12. Repeat steps 9-11 for opposite side.
13. Secure both side restraints to the kick panels using
the buckle.

CHECKING COOLING SYSTEM

Remove the filler cap and check coolant level. Coolant
level should be at the bottom of the standpipe in the
radiator neck. If coolant is required, add to bring coolant
PR835A
to the specified level and install the cap.
NOTE: If coolant is required, mix coolant for a
temperature of -36°C (-34°F). Follow mixing recom-
mendations of the manufacturer.
It is extremely important that the cooling system is
properly filled. If the system isn't properly filled,
engine damage will occur.

INSTALLING STEERING WHEEL

NOTE: The vehicle should be on level ground
with the front wheels oriented straight forward and
rearward.
1. Remove the nut and the steering wheel from the
steering shaft.
2. Install and align the steering wheel and loosely
secure with the nut.
PR834A
NOTE: This model has a castle nut/lock clip and
drilled steering shaft. The lock clip will be in the
steering wheel hardware package.
3. Verify that the steering wheel is oriented correctly
and the front wheels are aligned straight forward;
then apply one drop of red Loctite #271 to the
threads and tighten the nut to 34 N-m (25 ft-lb).
4. Install the lock clip through the steering shaft and
nut. Install the steering wheel cover.
PR831A
CAUTION
PR833
5