Toro UTV500AAC00000 Setup Instructions page 3

INSTALLING LEFT-SIDE FOOT
RESTRAINT
1. Remove the left-side foot restraint from the package
containing the side restraints.
2. Remove two sheet metal screws from the dashboard
attachment location and the second and third floor
retainer screws.
3. Remove the angle bracket from the foot restraint
(retain the screws) and attach to the floor using the
existing screws from the floor. Tighten securely.
4. Install the foot restraint and attach to the angle
bracket with the existing two cap screws. Do not
tighten at this time.
5. Secure the restraint and the dashboard with the
channel bracket (from the hardware pack) and two
sheet metal screws. Do not over-tighten.
6. Tighten the cap screws securing the restraint to the
angle bracket securely.
PR751A
INSTALLING ROPS/SEAT BELTS/
SIDE RESTRAINTS
The ROPS must be installed prior to operating the
PR752A
vehicle or delivery to a customer. Safety devices such
as taillight/brakelight, seat belts, and the passenger
hand holds are incorporated in the assembly. The
ROPS is part of the vehicle structure.
NOTE: The screws securing the front and rear
tubes during delivery will be used to secure the
ROPS tubes. There are nuts that secure the back
side of the ROPS tubes for shipping; these nuts
should be removed and discarded.
1. Loosen the Allen Head Screws securing the front
and rear ROPS tubes; then tip the front and rear
ROPS tubes from horizontal to vertical.
PR827
! WARNING
PR800A
PR827
3