Setup; Remove Side Deck Shipping Strap And Brace; Lowering The Front Deck Winglets - Toro 31598N Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Operator Training Material
Parts Catalog
Declaration of Conformity
Note: Determine the left and right sides of the machine
from the normal operating position.
Note: Some parts may have already been installed at the
factory.
1
Remove Side Deck Shipping
Strap and Brace
No Parts Required
Procedure
Remove the strap and brace securing the side decks for
shipping.
Description
No parts required
Deck cover R.H.
Deck cover L.H.
V-Belt
No parts required
No parts required
No parts required
No parts required
No parts required
Qty.
–
1
1
2
–
–
–
–
–
Qty.
1
Provide the operator with information on the use and
1
maintenance of the machine
1
1 Ordering parts
1
2
Lowering the Front Deck
Winglets
Parts needed for this procedure:
1 Deck cover R.H.
1 Deck cover L.H.
2 V-Belt
Procedure
1. Remove the nuts securing the front and rear stop bolts
to the right winglet deck mounts
2. While supporting the right winglet, remove the front
and rear stop bolts from the deck mounts
15
Use
Remove the side deck straps and brace
Lower the front deck winglets
Level the front center deck
Level the winglet decks to the front
center deck
Check the tire pressure
Check the fluid levels
Grease the machine.
Use
(Figure 3).
(Figure