Checking The Rear Wheel Toe-In - Toro 31598N Operator's Manual

Figure 75
1. Drain plug
4. When all of the oil has drained from both locations,
re-install the plug in the brake housing.
5. Rotate the wheel until the open holes in the planetary
are at the 11 and 1 o'clock position
1
Figure 76
1. Holes at the 11 and 1 o'clock position
6. Through either open hole, slowly fill the planetary
with .53-.59 liter (18–20 ounces) of high quality SAE
85W-140 wt. gear lube.
7. Reinstall the plugs.
8. Repeat the procedure on the opposite planetary/brake
assembly
Checking the Rear Wheel
Toe-In
Service Interval: Every 1,000 hours—Check the rear wheel
toe-in.
After every 1000 operating hours or annually, check the rear
wheel toe-in.
1. Measure the center-to-center distance (at axle height) at
the front and rear of the steering tires
front measurement must be no greater than 3 mm (1/8
inch) less than the rear measurement.
g021 156
2. Brake housing
(Figure 76).
G024858
(Figure 77). The
1. Center to center distance
2. To adjust, loosen the clamps at both ends of the tie
rods (Figure 77).
3. Rotate the tie rod end to move the front of the tire
inward or outward.
4. Tighten the tie rod clamps when the adjustment is
correct.
50
Figure 77
2. Tie rod clamps