Table of Contents
Advertisement
7.
Add enough oil to bring the level up to the bottom
of the check plug holes; refer to
Planetary-Gear-Drive Oil (page
8.
Install the plugs.
Checking the Rear Wheel
Toe-In
Service Interval: Every 800 hours
1.
Measure the center-to-center distance (at axle
height) at the front and rear of the steering tires.
Note:
The front measurement must be 6 mm
(1/4 inch) less than the rear measurement.
2.
To adjust, loosen the clamps at both ends of the
tie rods.
3.
Rotate the tie-rod end to move the front of the
tire inward or outward.
4.
Tighten the tie-rod clamps when the adjustment
is correct.
Cooling System
Changing the
Maintenance
56).
Cooling System Safety
•
•
•
•
Checking the Cooling
System
Service Interval: Before each use or daily
Check the coolant level at the beginning of each day.
The capacity of the system is 8.5 L (9 US qt).
The rotating fans and drive belts can cause
personal injury.
• Do not operate the machine without the
• Keep your fingers, hands, and clothing
• Shut off the engine and remove the key
1.
2.
58
Swallowing engine coolant can cause poisoning;
keep out of reach from children and pets.
Discharge of hot, pressurized coolant or touching
a hot radiator and surrounding parts can cause
severe burns.
– Always allow the engine to cool at least 15
minutes before removing the radiator cap.
– Use a rag when opening the radiator cap, and
open the cap slowly to allow steam to escape.
Do not operate the machine without the covers
in place.
Keep your fingers, hands and clothing clear of
rotating fan and drive belt.
DANGER
guards in place.
clear of the rotating fan and drive belt.
before performing maintenance.
Carefully remove the radiator cap and
expansion-tank cap
Check the coolant level in the radiator.
Note:
The radiator should be filled to the top
of the filler neck and the expansion tank filled
to the Full mark.
(Figure
72).
Advertisement
Table of Contents
