Table of Contents
Advertisement
Adding Fuel
Fill the tank to about 6 to 13 mm (1/4 to 1/2 inch)
below the top of the tank, not the filler neck, with
Number 2-D diesel fuel.
Note:
If possible, fill the fuel tank after each use; this
will minimize possible buildup of condensation inside
the fuel tank.
Checking the Tire Pressure
Service Interval: Before each use or daily
DANGER
Low tire pressure decreases machine side-hill
stability. This could cause a rollover, which
may result in personal injury or death.
Do not underinflate the tires.
The correct air pressure in the tires is 172 to 207 kPa
(25 to 30 psi).
Important:
Maintain the recommended pressure
in all tires to ensure a good quality of cut and
proper machine performance. Do not under-inflate
the tires.
Check the air pressure in all the tires before
operating the machine.
Figure 11
Checking the Torque of the
Wheel Lug Nuts
Service Interval: After the first hour
After the first 10 hours
Every 200 hours
Torque the wheel lug nuts to 115 to 136 N∙m (85 to 100
ft-lb) in the order shown in
g196909
23
Figure 12
Figure 13
and
Figure
Figure 13
Front Wheels
Figure 14
Rear Wheels
g001055
14.
g033358
g033359
Advertisement
Table of Contents
