Product Overview; Controls - Toro 30605TE Operator's Manual

Product Overview

Controls

Note:
Determine the left and right sides of the
machine from the normal operating position.
1. Brake pedal
2. Pedal-locking latch
3. Traction pedal
Traction Pedal
To stop the machine, reduce your foot pressure on
the traction pedal and allow it to return to the center
position (Figure 4).
Brake Pedals
There are 2 foot pedals that operate individual wheel
brakes for turning assistance, parking, and to aid in
better side-hill traction. A latch connects the pedals
for parking-brake operation and transport
Pedal-Locking Latch
The pedal-locking latch connects the pedals together
to engage the parking brake
Tilt-Steering Lever
Press the tilt-steering lever down to tilt the steering
wheel to the desired position, then release the lever
to lock the adjustment
Parking-Brake Latch
To engage the parking brake, connect the two pedals
together with the locking latch located behind the
Figure 4
4. Parking-brake latch
5. Tilt-steering lever
(Figure
(Figure 4).
(Figure 4).
pedal pads, and push down on the parking-brake latch
while you are pushing on the brake pedals
To release the parking brake, press the brake pedals
and the latch will disengage allowing the pedals to
come to the disengaged position. Ensure the pedals
have fully retracted after disengaging the parking
brake.
Key Switch
The key switch
O /P , and S
N REHEAT
g203048
1. Lift switches
2. PTO switch
3. Key switch
4. InfoCenter
Engine-Speed Switch
The engine-speed switch
change the engine speed. Tap the switch to increase
or decrease the engine speed in 100 rpm increments.
Hold down the switch to automatically move to High
or Low idle, depending on which end of the switch
you press.
4).
PTO Switch
The PTO switch has 2 positions: O
I ( ). Pull the PTO button out to engage the
N STOP
mower-deck blades. Push the button in to disengage
the mower-deck blades
High-Low Speed Control
The switch (Figure
increase for transporting the machine. To switch
between the High and Low speed ranges, raise the
cutting units, disengage the PTO and the cruise
control, put the traction pedal into the N
position, and move the machine at a slow speed.
17
(Figure 5) has 3 positions: O
.
TART
Figure 5
5. High-Low speed control
6. Engine-speed switch
7. Light switch (optional)
(Figure 5) has 2 modes to
UT
(Figure 5).
5) allows the speed range to
(Figure 4).
,
FF
g028453
( ) and
START
EUTRAL