Table of Contents
Advertisement
Pre-Maintenance
Procedures
Removing the Hood
1.
Unlatch and raise the hood.
2.
Remove the hairpin cotter securing the hood
pivot to the mounting brackets
Figure 41
1. Hairpin cotter
3.
Slide the hood to the right side, lift the other
side, and pull it out of the brackets.
Note:
Reverse this procedure to install the hood.
Lubrication
Greasing the Bearings and
Bushings
Service Interval: Every 50 hours—Lubricate all of the
(Figure
41).
The machine has grease fittings that you must
lubricate regularly with No. 2 lithium grease. Also,
lubricate the machine immediately after every
washing.
The grease-fitting locations and quantities are:
Traction Unit
•
•
g031613
•
•
47
bearings and bushings.
Every 500 hours/Yearly (whichever comes first)
2 front and rear-axle-pivot bushings
2 steering-cylinder-ball joints
2 tie-rod-ball joints
(Figure
2 king-pin bushings
(Figure
Lubricate the top fitting on the king pin
annually (2 pumps).
Figure 42
(Figure
42)
(Figure
43)
43)
43).
g004687
Advertisement
Table of Contents
