Table of Contents
Advertisement
1.39
Cutterdeck Position Control
The cutterdecks may be raised or lowered
independently using the bank of 3 lift control
levers.
To lower the cutterdecks, operate the lift control
levers in a downward direction until locked into
position. If the cutterdeck drive switch is in the
'on' position, the cylinder drive will engage when
the cutterdecks are approximately 300mm (11.8̋)
above ground level.
IMPORTANT: PREVENT DAMAGE - The
lift control levers must be locked in position 1
while moving. NEVER mow with the lift control
levers in position 2 (neutral).
To raise the cutterdecks, operate the lift control
levers in an upward direction and hold in
position 3. If the cutterdeck drive switch is in the
'on' position, the cylinder drive will disengage
when the cutterdecks are approximately 300mm
(11.8̋) above ground level. Release the lift control
levers when the cutterdecks are at the required
height. The control levers will automatically return
to position 2 (neutral).
Cutterdeck Drive Engagement
The cutterdeck drive can be engaged only when the
operator is seated correctly, refer to OPERATOR
PRESENCE CONTROLS.
Briefly operate the lift control levers to raise the
cutterdecks, thereby removing the cutterdeck
suspension deadweights and wing units stored
energy reaction from the transport latch mecha-
nisms.
Release the cutterdeck latches. Operate the cutter-
deck position controls to the down / float position
and lower all cutterdecks to the ground ready for
mowing.
Forward rotation cutterdeck drive engagement:
Operate the cutterdeck drive switch to the 'On'
position.
To disengage all cutterdeck drives: Operate the
cutterdeck drive switch to the 'Off' position.
WARNING: PREVENT ACCIDENTS - Refer
to OPERATOR PRESENCE CONTROLS for
additional information.
OPERATING THE MOWER
1
2
1. On
2. Off
1
2
3
4
5
1. Down/float
2. Neutral
3. Raise
4. LH wing
5. Centre
6. RH wing
1.39
6
Advertisement
Table of Contents
