Every 250 Hours - Toro 02770 Operator's Manual

1.52

Every 250 Hours

Perform routine checks: Refer to - DAILY BEFORE USE.
Check battery condition:
WARNING: PREVENT ACCIDENTS - Explosive gases are produced by the battery. Work in a well
ventilated area, away from all sources of ignition.
Battery fluids are corrosive. Take care to avoid contact with the skin or eyes. In the event of a
spillage, drench the affected area with water. If the eyes are affected, seek medical attention.
Remove any contaminated clothing and clean thoroughly before use.
When removing the battery, always disconnect the negative (-) cable first.
When replacing the battery, always connect the negative (-) cable last.
Remove the tool tray to gain access to the battery. Remove any corrosion from the battery terminals using a
wire brush and apply petroleum jelly to the terminals to prevent further corrosion. Clean the battery compart-
ment.
Under normal operating conditions the battery will not require any further attention. If the machine has been
subject to continuous use under high ambient temperature conditions, the battery electrolyte may require top-
ping up. Remove the cell covers and top up with distilled water to a height 15mm below the top of the battery.
Replace the cell covers.
IMPORTANT: PREVENT DAMAGE - Check
the condition of the battery cables. Replace cables
showing signs of wear or damage and tighten any
loose connections as necessary.
Visually inspect transmission control cable and
operating mechanism:
Check the condition and security of the cable and operating mechanism at the speed control pedals and trans-
mission pump ends.
- Remove build up of dirt, grit and other deposits.
- Ensure that the ball joints are securely anchored and check that mounting brackets and cable anchors are
tight and free from cracks.
- Inspect end fittings for wear, corrosion, broken springs and replace if necessary.
- Ensure that the rubber seals are correctly located and in good condition.
- Ensure that the articulating sleeves supporting the inner cable are in good condition and firmly
attached to the outer cable assembly at the crimped connections. If there are any signs of cracking or
detachment fit new cable immediately.
- Check that sleeves, rods and inner cable are free from bends, kinks and other damage. If there are
any signs of such failure, fit a new cable immediately.
- Check the condition of the neutralising device and replace if worn.
- With the engine switched 'Off', operate the pedal controls through the entire range and ensure that
the mechanism moves smoothly and freely to the neutral position without 'Sticking' or 'Hanging up'.
MAINTENANCE
- EVERY 50 HOURS.
Outer Cover
1
Rubber Seal Sleeve
1.52
1. Battery
2. Tool tray
2
Rubber Seal Rod End