Table of Contents
Advertisement
Brake Maintenance
Adjusting the Parking Brake
Service Interval: After the first 100 hours
Every 500 hours thereafter
Check to make sure brake is adjusted properly. This procedure
must be followed after the first 100 hours or when a brake
component has been removed or replaced.
1. Drive the machine onto a level surface.
2. Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
3. Stop the engine, wait for all moving parts to stop, and
remove the key.
4. Raise the back of the machine up and support the
machine with jack stands.
DANGER
Mechanical or hydraulic jacks may fail to
support the machine and cause a serious
injury.
• Use jack stand when supporting the
machine.
• Do not use hydraulic jacks.
5. Remove the rear tires from the machine.
6. Remove any debris from the brake area.
7. Rotate the drive wheel release handle
to the released position; refer to
Using the Drive Wheel Release Valves (page 27).
8. Measure the overall length of the compression
spring. The correct length should be between
3.8 and 4.0 cm (1-1/2 and 1-9/16 inches). If the spring
length is within this range, no adjustment is needed. If
it is not, proceed to step 9.
9. Hold the threaded rod end with a tool and adjust
the lock nut until the spring length is between
3.8 and 4.0 cm (1-1/2 and 1-9/16 inches) (Figure 71).
Note: Do not allow the cable to turn when the nuts
are being loosened.
Left Hand Brake Shown
1. Cable anchor
2. Hold threaded rod here
3. Measure
4. Lock nut
10. Disengage the parking brake.
11. Turn the wheel hub by hand in both directions relative
to the caliper.
Note: Ensure that the caliper pad does not contact
the wheel hub.
12. If there is no movement between the hub and the
caliper then repeat the adjustment (drive release valves
must be in the released position on the hydros).
13. After adjusting the brakes on both sides of the mower,
cycle the brake handle a minimum of six times to allow
the cable to seat into the sheath and mounting tabs.
14. Check the spring length; engage the park brake and
repeat steps 8 through 12 if the length is not in the
correct range.
15. Rotate the drive wheel release handle
to the operating position; refer to
Using the Drive Wheel Release Valves (page 27).
16. Install the rear tires and torque lug nuts between 122
and 129 N-m (90 and 95 ft-lb).
17. Remove the jack stands.
47
Figure 71
5. Caliper
6. Compression spring
7. Threaded rod
8. Hub
Advertisement
Table of Contents
