Operating The Throttle; Operating The Choke; Operating The Ignition Switch; Using The Fuel-Shutoff Valve - Toro 74942TE Operator's Manual

Operating the Throttle

You can move the throttle control between F
positions (Figure 15).
Always use the F position when turning on the mower
AST
deck with the blade-control switch (PTO).

Operating the Choke

Use the choke to start a cold engine.
1. Pull up the choke knob to engage the choke before
using the ignition switch
2. Push down the choke to disengage the choke after the
engine has started
1
2
1. On
and S
AST
G008946
Figure 15
(Figure 16).
(Figure 16).
G008959
Figure 16
2. Off

Operating the Ignition Switch

1. Turn the ignition key to the S
LOW
Note: When the engine starts, release the key.
Important: Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, wait 15 seconds between attempts. Failure to
follow these instructions can burn out the starter
motor.
Note: You may need multiple attempts to start the
engine when you start it the first time after the fuel
system has been without fuel completely.
2. Turn the ignition key to the S
the engine.

Using the Fuel-Shutoff Valve

The fuel-shutoff valve is located under the seat. Move the
seat forward to access it.
Close the fuel-shutoff valve for transport, maintenance, and
storage.
Ensure that the fuel-shutoff valve is open when starting the
engine.
1. On
20
TART
G008947
Figure 17
position to shut off
TOP
1
2
G008948
Figure 18
2. Off
position (Figure 17).