Table of Contents
Advertisement
Figure 68
1. Hydraulic unit shrouds
6. Over each dipstick, remove the cover and the bolt
attached to the cover . Clean around each dipstick and
hydraulic unit
(Figure
2
1
Figure 69
1. Cover
7. Position the seat.
69).
G012434
2. Bolt
Brake Maintenance
Adjusting the Parking Brake
Service Interval: After the first 100 hours
Every 500 hours thereafter
Check that the brake is adjusted properly before adjusting.
1. Drive the machine onto a level surface.
2. Disengage the blade-control switch (PTO), move the
motion-control levers to the N
and engage the parking brake.
3. Shut off the engine, wait for all moving parts to stop,
and remove the key.
4. Raise the back of the machine and support the machine
with jack stands.
DANGER
Mechanical or hydraulic jacks may fail to
support machine and cause a serious injury.
• Use a jack stand when supporting the
machine.
• Do not use hydraulic jacks.
5. Remove the rear tires from the machine.
6. Remove any debris from the brake area.
7. Rotate the drive-wheel release handle to the released
position. Refer to
Valves (page
27).
8. Check if there is a visible gap between the L-bracket
and the linkage stop
Left Side Shown
1. L-bracket
2. Linkage stop
3. Gap
48
-
EUTRAL
LOCK
Using the Drive-Wheel Release
(Figure
70).
Figure 70
4. Rear-linkage assembly
5. Caliper
6. Wheel hub
position,
Advertisement
Table of Contents
