Table of Contents
Advertisement
g024179
Figure 90
1. Measure here from blade
to hard surface
5. Rotate the opposite ends of the blades forward.
6. Measure from a level surface to the cutting edge of the
blades at the same position as in step 4.
Note: The difference between the dimensions
obtained in steps
4
and
(1/8 inch).
Note: If this dimension exceeds 3 mm (1/8 inch), the
blade is bent and must be replaced.
WARNING
A blade that is bent or damaged could break
apart and could seriously injure or kill you or
bystanders.
• Always replace bent or damaged blade
with a new blade.
• Do not file or create sharp notches in the
edges or surfaces of the blade.
1
2. Position A
6
must not exceed 3 mm
Removing the Blades
Important: The right blade on this mower deck is
counter-rotating and uses a left-threaded blade bolt. Use
Figure 92
for the correct placement of the mower blades.
Replace a blade if it hits an object, if the blade is out of balance,
or if the blade is bent. To ensure optimum performance and
continued safety conformance of the machine, use genuine
Toro replacement blades. Replacement blades made by other
manufacturers may result in nonconformance with safety
standards.
1. Hold the blade end using a rag or thickly-padded glove.
2. Remove the left and center blade bolt, curved washer,
and blade from the spindle shaft
3. Remove the right blade bolt (left threaded bolt), curved
2
washer, and blade from the spindle shaft
Note: Note the type of blade and where each blade is
installed. See
Left and Center Spindle Shown
1. Sail area of the blade
2. Blade
60
(Figure
Figure 92
for the correct position.
Figure 91
3. Curved washer
4. Blade bolt
91).
(Figure
92).
Advertisement
Table of Contents
