Table of Contents
Advertisement
Adjusting the Skid(s)
Mount the skids in the lower position when operating in
height of cuts higher than 64 mm (2-1/2 inches) and in the
higher position when operating in height of cuts lower than
64 mm (2-1/2 inches).
Note: When the skids become worn, switch the skid to the
opposite sides of the mower, flipping them over. This will
allow you to use the skids longer before replacing them.
1. Disengage the PTO and set the parking brake.
2. Move the throttle lever to the S
the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the carriage bolts and nuts from each skid
(Figure
29).
1
g024244
1. Carriage bolt
2. Skid
4. Move each skid to the desired position and secure them
with the carriage bolts and nuts.
Note: Only use the top or center sets of holes to
adjust the skids. The bottom holes are used when
switching sides on the mower deck, at which time they
become the top holes on the other side of the mower.
5. To prevent damaging the skid, torque the carriage bolts
and nuts for each skid to 12.4 to 14.7 N·m (110 to 130
in-lb).
position, shut off
LOW
2
3
Figure 29
3. Nut
Positioning the Seat
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
To adjust the seat, move the lever sideways to unlock seat
(Figure
30).
g019754
Changing the Seat Suspension
The seat adjusts to provide a smooth and comfortable ride.
Position the seat where you are most comfortable.
To adjust the seat, turn the knob in front either direction to
provide the best comfort
1
1. Seat-suspension knob
26
Figure 30
(Figure
31).
g019768
Figure 31
Advertisement
Table of Contents
