Toro 25450W Operator's Manual page 32

Figure 36
1. Display brightness
indicator
2. Decrease brightness
Accessing the Trencher Diagnostics Function Screen
You will need a PIN to access this screen; to obtain the PIN,
contact an Authorized Toro Distributor.
Accessing the Trencher Errors Information Screen
You will need a PIN to access this screen; to obtain the PIN,
contact an Authorized Toro Distributor.
Accessing the Engine Errors Information Screen
You will need a PIN to access this screen; to obtain the PIN,
contact an Authorized Toro Distributor.
3. Increase brightness
4. Return to the previous
screen
Setting the Front and Rear Steering
Positions
Note: This procedure requires that you have the PIN
number, which you can obtain from an Authorized Service
Dealer.
1. Press button number 2 [Trencher (traction unit) setup]
on the main-selection screen; refer to
Main-Selection Screen (page
2. Enter the following programming modes by entering
the PIN for the following functions:
Note: To access the computer function for
the machine, you must enter the unique 8-digit
identification number assigned to the set of functions.
•
Maintenance-clearing (8-digit PIN)
•
Diagnostic (8-digit PIN)
Note: The numbers (1, 2, and 3) and the letters (A,
B, and C) shown on the display screen are not the
functional PIN numbers.
Each button enters into the PIN as follows:
•
Button 1 enters the number 1
•
Button 2 enters the number 2
•
Button 3 enters the number 3
•
Button 5 enters the letter A
•
Button 6 enters the letter B
•
Button 7 enters the letter C
Note: Numbers 1, 2, 3, 5, 6, and 7 are the only numbers
that can be used for the PIN.
1. Buttons for corresponding
PIN numbers
2. PIN entry appears here
32
Accessing the
30).
(Figure 37)
(Figure 37)
(Figure 37)
(Figure 37)
(Figure 37)
(Figure 37)
Figure 37
3. Enter PIN
4. Return to the previous
screen