Connecting The Computer-Module Connectors; Connecting The Alternator Wiring; Closing The Machine; Cleaning - Toro 25450W Operator's Manual

Connecting the
Computer-module Connectors
1. Connect the 38-socket connector (CPU-2) to the back
of the computer module
2. Connect the 50-socket connector (CPU 1) to the back
of the computer module
3. Align the lower-console panel to the console
116).
4. Secure the panel to the console with the 4 hex-flanged
head bolts (6 x 20 mm).
Connecting the Alternator
Wiring
1. Ensure that the battery-disconnect switch is in the Off
position; refer to Battery-Disconnect Switch (page
2. Connect the 4-socket connector for the voltage-sense
wire to the 4-pin connector on top of the alternator
(Figure 115).
3. Assemble the terminal of the charge wire onto the stud
at the back of the alternator
4. Secure the charge wire to the stud with the nut and
washer.
5. Align the boot of the charge wire over the terminal
and stud (Figure 115).

Closing the Machine

1. Rotate the battery-disconnect switch to the On
position; refer to Battery-Disconnect Switch (page
2. Install the right side panel; refer to
Panels (page 46).
(Figure 117).
(Figure 117).
(Figure
(Figure 115).
Installing the Side

Cleaning

Removing Dirt and Debris from
the Machine
Important: Operating the engine with blocked screens,
dirty or plugged cooling fins, and/or cooling shrouds
removed, will result in engine damage from overheating.
1. Lower all attachments and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Wipe away dirt and debris from the air cleaner.
4. Clean any dirt and debris buildup on the engine with a
brush or blower.
Important: It is preferable to blow dirt out, rather
21).
than washing it out. If water is used, keep it away
from electrical items and hydraulic valves. Do
not use a high-pressure washer. High-pressure
washing can damage the electrical system and
hydraulic valves or deplete grease.
21).
76