Toro 25450W Operator's Manual page 59

Figure 85
1. Wheel hub
2. Oil port at the 6 o'clock
position
3. Drain pan
2. Place a drain pan under the oil port of the wheel hub
(Figure 85).
3. Remove the plug and drain the oil from the planetary
(Figure 85).
4. Check the condition of the O-ring for the plug.
Note: Replace the O-ring if it is worn or damaged.
5. Move the machine forward or backward until the oil
plug for the wheel hub is either at the 3 o'clock or the 9
o'clock position (Figure
6. Add the specified oil to the wheel hub through the oil
port until the oil level is at the bottom of the threads
of the port.
7. Install the plug in the oil port of the wheel hub.
8. Repeat this procedure for the other wheel hubs.
Checking the Oil Level in the Axles
Service Interval: After the first 100 hours
Every 250 hours
1. Place a drain pan under the pinion housing of the axle.
2. Remove the plugs from the sight port in the pinion
housing of the axle
4. Oil port at the 3 o'clock
position
5. Plug
6. Oil-servicing equipment
85).
(Figure 86 and Figure 87).
1. Front-axle housing
2. Plug
1. Rear-axle housing
2. Forward
59
Figure 86
Front Axle
3. Sight port
Figure 87
Rear Axle
3. Plug
4. Site port