Toro 25450W Operator's Manual page 46

Figure 60
1. Latch lever
2. Latch button
4. Lift the panel up and then away from the machine
(Figure 61).
Figure 61
1. Latch
3. Side-panel latch
2. Side panel
Installing the Side Panels
1. Align the side panel with the machine frame.
2. Align the mounting bolt at the top of the side panel
with the hole in the support flange of the hood panel
(Figure 62).
1. Hole (support
flange—hood panel)
2. Mounting bolt
3. Apply light inward pressure against the panel at 1 of
the latches.
4. Set the latch by pushing in the latch lever
5. Repeat steps 3 and
6. If the backhoe is installed on the machine, do the
following substeps:
A. Rotate the front end of the walkway to its original
position (Figure
B. Align the hole in the walkway with the hole in the
walkway support bracket
C. Install the retaining pin through the holes.
46
Figure 62
3. Hood panel
4. Side panel
(Figure
4 at the other latch.
59).
(Figure 59).
60).