Replacing A Fuse - Toro 25450W Operator's Manual

6. Connect the negative (-) jumper cable to a ground
point, such as the nut at the pivot point for the
alternator (Figure 78).
7. Start the engine; refer to steps
the Engine (page 33).
Note: If the engine starts and then stops, do not
operate the starter motor until the starter motor stops
turning. Do not operate the starter motor for more
than 30 seconds at one time. Wait 30 seconds before
operating the starter motor to cool the motor and to
build up the charge in the battery.
8. When the engine starts, have the other person
disconnect the negative (-) jumper cable from the frame
and then disconnect the positive (+) jumper cable.
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery, and keep sparks and
flames away from the battery.
Important: Always keep the battery fully charged. This
is especially important to prevent battery damage when
the temperature is below 32°F (0°C).
1. Clean the exterior of the battery case and the battery
posts.
Note: Connect the leads of the battery charger to
battery posts before connecting the charger to the
electrical source.
2. Connect the positive lead of the battery charger to the
positive-battery post
4
2
1. Positive-battery post
2. Negative-battery post
3. Connect the negative lead of the battery charger to the
negative-battery post
1 through 4 in
(Figure 80).
3
1
G003792
Figure 79
3. Red (+) charger lead
4. Black (-) charger lead
(Figure 79).
4. Connect the battery charger to the electrical source.
Important: Do not overcharge the battery.
Note: Charge the battery as shown in the following
Starting
table:
Battery Charging Settings and Times
Charger Setting
4 to 6 amperes
25 to 30 amperes
5. When the battery is fully charged, unplug the charger
from the electrical source, then disconnect the charger
leads from the battery posts

Replacing a Fuse

1. Remove the left and right side panel; refer to
the Side Panels (page
2. Rotate the battery-disconnect switch counterclockwise
to the Off position
1. Battery-disconnect switch
in the On position
3. Remove the 4 hex-flanged bolts (5/16 x 3/4 inch) that
secure the cover to the console and remove the cover
(Figure
55
Charging Time
30 minutes
10 to 15 minutes
(Figure
45).
(Figure 80).
Figure 80
2. Battery-disconnect switch
in the Off position
81).
79).
Removing