Table of Contents
Advertisement
6
Installing the Cutting Units
Parts needed for this procedure:
Cutting unit (order separately; contact your authorized
3
Toro distributor)
3
Grass basket
3
Electric counterweight
6
Capscrew
3
O-ring
Procedure
1.
Prepare the cutting units for installation; refer to
your cutting unit Operator's Manual.
2.
Apply grease to the inside spline of the drive
coupler.
3.
Install an O-ring to each reel motor as shown
in
Figure
8.
4.
Secure the electrical counterweight to the
existing counterweight with 2 capscrews as
shown in
Figure
Figure 8
9.
1. Capscrew
2. Electrical counterweight
5.
Install the cutting units; refer to
Cutting Units (page
6.
Install each grass basket onto the grass-basket
hooks.
7
Connecting the Main-Power
Connectors
No Parts Required
Procedure
Raise the connector cover and plug in the main-power
connectors located near the base of the roll bar on the
left side of the machine
g256064
14
Figure 9
3. Existing counterweight
Installing the
50).
(Figure
10).
g036342
Advertisement
Table of Contents
