Table of Contents
Advertisement
Note:
When you install the 3-Wheel-Drive Kit, the kit
is automatically enabled.
Setting the Battery-Reserve
Capacity
Navigate to the B
. R
ATT
amount of distance needed to transport the machine
to the shop. This allows you to have enough battery
power (when the battery level becomes too low) to
transport the machine to the shop for recharging; refer
to
Monitoring the Battery-System Charge Level (page
33).
Note:
You can adjust the distance from 0.8 km (0.5
mi) to 8 km (5 mi) in 0.8 km (0.5 mi) increments.
Understanding the
InfoCenter Dialog
Messages
When the machine is being calibrated, dialog
messages appear in the InfoCenter. These messages
are intended to instruct you through the calibration
process.
Refer to the following table for a list of each dialog
message:
Dialog Messages
Message
InfoCenter Message Text
Number
1
Return pedal to neutral
4
Move pedal to max forward and hold
5
Max forward calibration passed
9
Max forward calibration failed. Voltage out of spec
13
Move pedal to max reverse and hold
14
Max reverse calibration passed
16
Max reverse calibration failed. Voltage out of spec
17
Calibration failed. Pedal position unknown
18
Return pedal to neutral. Continue?
100
Calibration is engaged
101
Calibration is complete
102
Cycle the key switch
110
Inhibit calibration. Component not responding
111
Inhibit calibration. Component not ready
112
Inhibit calibration. Fault active
113
Inhibit calibration. Not in seat
114
Inhibit calibration. Not in neutral
115
Inhibit calibration. In neutral
option to set the
ESERVE
Dialog Messages (cont'd.)
116
Inhibit calibration. Parking brake is engaged
300
Return pedal to neutral
301
Center steering wheel. Continue?
302
Manually center rear wheel. Continue?
303
Steer rear wheel max left. Continue?
304
Steer rear wheel max right. Continue?
305
Rear wheel center out of range
306
Rear wheel angle out of range
400
Caution: Machine must be on jack stands.
Continue?
401
Inhibit calibration. Contactor open
402
Inhibit calibration. Pedal in Neutral
403
Return pedal to neutral
404
Wait for wheels to stop
405
Move pedal to max forward and hold
406
Calibration active. Hold pedal
500
Lift/Lower extend active
501
Lift/Lower retract active
502
Move joystick to lower position
503
Move joystick to raise position
504
Is the cutting unit installed? Continue?
1100
Traction diagnostic messages enabled
1101
Steering diagnostic messages enabled
Tilting the Steering Wheel
You can tilt the steering wheel to a comfortable
operating position.
1.
Loosen the bolts
steering-wheel assembly to the steering arm.
28
(Figure
26) that secure the
Advertisement
Table of Contents
